ENSEEL Acrylic Sealer and Undercoater 4/1 Gal. Case (NCL0504-29)
** Please note: shipping lead time 3-7 business days
Product Description
An all acrylic, water emulsion sealer that protects floor surfaces from water, dirt and abrasive wear. This product provides floor maintenance cost savings by eliminating frequent strippings and re-coatings. This pure acrylic brilliant primer is produced in high pressure reactors using proprietary designed polymer emulsions, interacted plasticizers, leveling aids, antifoam agents and deionized water to insure maximum performance.
Directions
Floor Preparation: Strip floor thoroughly with your preferred NCL floor stripper, making sure that all old film is removed. Rinse completely and allow to dry.
Application of Sealer: Using a clean string mop or applicator, apply a thin even coat of ENSEEL™ Acrylic Sealer and allow to dry for at least 30 minutes. On very porous floors apply a thick coat and allow to soak 5 minutes. Pick up excess, if any, before ENSEEL™ Acrylic Sealer begins to dry. To increase the appearance of the surface a second coat may be applied. After ENSEEL™ Acrylic Sealer has been allowed to completely cure, apply the recommended NCL Floor Finish following recommendations on product label.
Safety
KEEP OUT OF THE REACH OF CHILDREN
Precautionary statement:
Prevention: Observe good industrial hygiene practices.
Response: Wash thoroughly after handling.
Storage: Store away from incompatible materials.
Disposal: Dispose of contents/container in accordance with local/regional/national/international regulations.
This product is not known to be a "Hazardous Chemical" as defined by the OSHA Hazard Communication Standard, 29 CFR 1910.1200.
Additional safety measures:
Read the entire label and SDS before using this product, and for additional first aid measures. SDS for this product is available under the Documents tab.e.com
Documentation
Technical Data Sheet Enseel TDS English GHS.pdfSafety Data Sheet ENSEEL SDS English.pdf
Miscellaneous Documents Ingredient Disclosure - Enseel
Product Specs
- Type ... Acrylic
- pH ... 8.1
- Re-coat ... 45 minutes
- Volatile hydrocarbon solvents ... None
- Drying time (minutes) ... 20
- Color of dried film ... White
- Color of liquid ... White
- Coverage (sq. ft. / gal) ... 1st coat 1500 - 1800
- ... 2nd coat 1800 - 2000
- Flash point ... Not available
- Viscosity (cps) ... < 10 cP
- Stability ... Excellent
- Sediment (%) ... < 0.05
- Density (lbs/gal) ... 8.5 ± 0.1
- Specific gravity (g/cc) ... 1.02 ± 0.01